★★★★★ 5.0 · 334 reviews on Google →

Licensed & Insured · CMC-A #81936

Nashville Metro Plumbing

Gas Line Services in Nashville, TN

Licensed gas work across the Nashville metro: new lines for ranges, grills and generators, leak detection when something smells wrong, repairs, pressure testing and the permit that proves it was done right.

Gas line work by 100 Percent Plumbing in Franklin, TN

A real Franklin job

Gas work is code work

Sizing, pressure, and venting are not places to improvise. We pull the permit and get it inspected, because an inspection is the only independent confirmation the line was done right.

What Gas Work Covers

Gas is the one system in a house where the failure mode is not a puddle. That is why every part of it is specified: what the pipe is made of, how it is sized for the appliance load, what pressure it runs at, how it is supported, and how the appliance is vented. It gets permitted and an inspector signs it off, and that inspection is the only independent proof the work was done correctly.

In practice most of what we are called for falls into two jobs. Either something is wrong with a line that already exists, or you want gas somewhere it has never been. Each has its own page.

Replacing an Existing Line

Lines get replaced for three main reasons. Corrosion on older black iron, particularly where it runs through a damp crawlspace or passes through an exterior wall. A line that was adequate for what it originally fed and is not sized for what has been added since. Or work done previously without a permit, which has to be corrected before anything new can be inspected.

We run black iron for most interior work, CSST where the routing calls for it, and polyethylene underground. Whichever it is, the line is pressure tested and permitted. The test is what tells you it is right rather than probably right, and it is the part a lot of unpermitted work skips.

Other Gas Work We Handle

Appliance connections for ranges, cooktops, dryers and water heaters

Outdoor lines for grills, fire pits, patio heaters and pool heaters

Standby generator connections, sized for the run and the load

Pressure testing and certification, including after other trades have worked on a line

Capping and safely decommissioning lines that are no longer used

Shutoffs, sediment traps and connectors brought up to current code

Commercial kitchen equipment connections and building gas systems

Warning Signs Something Is Wrong

If you smell gas, do not troubleshoot it. Leave the building, call the gas company from outside, and call us once the immediate hazard is handled.

A rotten egg or sulfur smell, which is the odorant added to gas so you can detect it

Hissing near an appliance, a connector or a buried line

Pilot lights that keep going out, or burners that will not stay lit

A sharp drop in gas pressure, or appliances that suddenly underperform

An unexplained spike in the gas bill

Dead or dying vegetation in a line over a buried run

Why Call Us

5.0-star rating across 334 Google reviews

Licensed for gas line work, CMC-A #81936

Emergency service available, we answer the phone 24 hours a day

We pull the permit and get the work inspected

Common Questions

What drives the cost of gas line work?

Run length, whether the line is exposed or has to go through finished space, the pressure and sizing required for the appliance, and permit and inspection requirements. Gas work is code work, and the code is not optional.

Do I need a permit for a gas line?

Usually yes, and that is a good thing. Permitted work gets inspected, which is the only independent confirmation that a gas line was installed correctly. We handle the permitting as part of the job.

Can you run gas to a grill or a fire pit?

Yes, and it is one of the more common jobs we do. The work is the same discipline as anything else: the line gets sized for the appliance, buried or supported to code, pressure tested and inspected. See gas line installation for what that involves.

Do you do gas leak detection?

Yes. If you smell gas, leave the house and call the gas company first, then call us. Once the immediate hazard is handled we locate the leak and repair it properly rather than patching around it. More on leak detection and repair.

More on how we price our work, including why we quote a fixed price instead of charging by the hour.

Smell gas? Call now.

Emergency gas line service across the Nashville metro, and we answer the phone 24 hours a day. For anything that is not urgent, the onsite estimate is free.

Prefer email? hello@100percentplumbingtn.com

Call now 615-431-1100